NIKOLATOY 25cm Super RRTrent 900 Turbofan Engine Model with Brushless Motor Pre-Assembled Decoration Science Discovery T

Note This product is finished assembled you do not need to assemble it by yourselfDue to the difference between the measurement the dimension and weight may have little error Specification Manual Brand NikolaToyProduct Name NIKOLATOY brushless motor super turbofan engine model decorationMaterial PLACraft High precision 3D printing technologyProduct Size 25cmX12cmX10cmProduct Weight 480gPackage Size 860gPackage Weight 29cmX16cmX17cmUsing Notes 1 When removing and putting the engine back from the base please make sure that the power is off 2 Before turning the forward and reverse raotation switch please push the throttle push rod back to ensure that it is switched when not rotating or at low speed status to reduce the impact damage to the brushless motor coupling 3 The engine is in car mode at low speed and in crossing mode at high speed The system will switch modes when the throttle push at a certain point and the engine may shake which is a normal phenomenon 4 It can work for a long time in half throttle state and supports charging while rotating Do NOT charge in full throttle state to avoid excessive heating and possible damage to the engine when it is unattended for a long time 5 When fully charged it can run for about 30 minutes at full throttle in forward rotation It is best to run for less than 15 minutes at full throttle in reverse rotation the wind blown out by forward rotation can dissipate the heat of the brushless motor and the heat dissipati